Emergency LED Full Light Bars For Police Construction, EMS

Product design:

1) Summary:

    This product adopts double-layer aluminum alloy boards structure and sector design, which has distinct outline stronger percussion-resistant capability, and is not easy to lose color and get aged. Moreover, the caution light has good sealing and waterproof. A lot of LED lights are distributed as a ring and use high power LED lights let it give out strong flash from each direction. And it has advantage with high brightness and low power waste. Even in extremely complicated, circumstances, it can transmit emergency signal correctly. The controller of the light bar can choose several modes to flash the light.

2) Specifiation:

3)Packing Information:

Packing Size	1235x350x180mm
Qty/CTN	1PCS

4) Installation of the warning light bar




a) Put light bar on the roof of the vehicle, base on the vehicle's size, adjusting the frame to fit it, And Then let the catches button the rainwater line on both side of the vehicle and screwing the nut by wrench. (Re. Figure 1 below)
b) After installed, firstly, according the color, plug the six wires one by one to the controller, ensure every wire not to meet each other, then connect the two main red and black electrical wires to the battery (red to +, black to -) (Re. Figure 2 below).

NOTICE: the controller connection should must be made before it connects to battery. And must use insulating tape tie up every of six wires of controller, ensure they can not to short. Otherwise the controller will be damaged.

5) Controller



a) The power switch that on the one side of the controller is control the power supply of the light bar and controller.
b) Switch LEFT ALLEY control the left alley light. Press one time for lighting; press again for turn off.    
c) Switch RIGHT ALLEY control the right alley light. Press one time for lighting; press once more for turn off.
d) Switch TAKE DOWN control the front lights. Press one time for lighting; press once more for turn off.
e) Switch Full Flashing control the 18 PCs flashing lights to flashing or turn off.
f) Switch change the main flashing lights to backward a pattern.
g) Switch change the main flashing lights to next a pattern.
h) Switch ← control the direct lights flash towards left. Press once for turn on, press once more for turn off.
i) Switch ↑ control the direct lights to flashing. Press once for turn on, press once more for turn off
j) Switch → control the direct lights flash towards right. Press once for turn on, press once more for turn off
k) Switch FLASHING LIGHTS control the 12 PCs flashing lights to flashing. Press once to flashing, press once more to turn off.


Workshop:


Applications:
Police, Fire, The Automotive, Police, Fire, Motorcycle, Construction,Emergency Vehicle and School Bus Industries